Close the Liftgate and Lock the Vehicle
Use the dedicated equipped-liftgate button to close the cargo opening, lock every door and arm the alarm in one action.
A power liftgate may require a specific trim, sensor position or setup sequence. Use the vehicle and year shown on each guide, then check its equipment note before trying the steps.
Each guide keeps its market, model-year, powertrain and equipment limits attached. A listed model does not imply the feature is standard on every trim.
Use the dedicated equipped-liftgate button to close the cargo opening, lock every door and arm the alarm in one action.
Control an equipped 2024 Levante liftgate with sequential key-fob commands.
An enabled advanced-keyless Mazda3 can lock after its doors and liftgate or trunk close and the carried key leaves the operating range.
Carry the key and press the liftgate's door-lock switch to lock the vehicle first and then close the power liftgate automatically.
The enabled proximity setting locks the doors and liftgate after the last opening is closed and the carried key leaves the operating range.
With the vehicle off and stopped, hold the key's liftgate button for at least one second to open or close the gate.
Stop the gate above halfway and hold its close switch for three seconds; two beeps store the new ceiling-safe height.
Stop the liftgate above halfway and hold its close switch for three seconds to save clearance for a low garage.
Press Unlock three quick times and hold it on the fourth press to lower every initialized power window before you enter.
When enabled, the advanced-keyless system can lock after all openings close and the carried key leaves the operating range.
Position the open liftgate above halfway and hold its close switch for three seconds; two beeps store that height.
The enabled proximity function locks after the final door and liftgate close and the carried key moves beyond operating range.
Use one deliberate kick below the rear bumper while carrying the SmartKey to operate the powered tailgate.
Store a stop in the upper half of the liftgate travel to protect it from a low garage ceiling.
On an equipped Eclipse Cross, a deliberate foot motion under the rear sensor area can operate the power tailgate while the valid FAST-Key is nearby.
Carry the key, clear the rear of the vehicle and make one deliberate foot motion at the bumper sensor.
Hold the open liftgate at a safe height and save that position so it clears a low garage ceiling on future openings.
Carry the Intelligent Key and make one quick kick beneath the left side of the rear bumper to open the equipped liftgate hands-free.
Carry the Intelligent Key and make one quick straight kick beneath the center of the rear bumper.
Hold the open liftgate at a chosen height and save it with the liftgate switch until two beeps sound.
Use a short in-and-out kick below the center of the rear bumper while carrying the Intelligent Key.
Move the open liftgate to a safe custom height and save that position with the liftgate switch.
Release the spring-loaded step with a foot and retract it without placing hands in the low-clearance mechanism.
Use the 60/40 swing-door mode for closer bed access without first lowering the tailgate.
Operate an equipped 2025 Ram 1500 tailgate from the fob or truck controls and reset its latch after a failed close.
Open the powered outlet panel, enable outlet power and keep combined loads within Tesla's documented limits.
Store a reduced trunk opening for low ceilings and clear saved locations when full height is needed again.
Store a lower liftgate stop for a garage or location and clear it later from Service settings.
Use one quick in-and-out foot motion at the lower-right bumper sensor while carrying the electronic key.
Stop the power liftgate at a safe height and store that position with its lower switch.
Save a lower liftgate stop position for a low garage or easier reach, then restore the default when needed.
Use one quick in-and-out foot motion under the rear bumper while carrying the electronic key.
Lock the side doors immediately and queue liftgate locking for the end of its powered close cycle.
Request liftgate closing and door locking, then move away with the key during the standby buzzer.
Back-door reserve lock secures the side doors immediately and finishes locking the power liftgate after it reaches the fully closed position.
Store a reduced opening position for low garage ceilings or easier reach, then restore the factory position with a longer button hold.
Open the matching vehicle guide and read its availability note first. When the retail trim or package is not named by the official source, use the window sticker, manufacturer build record or the visible control in the vehicle.