On a 2025 TRD Off-Road Premium i-FORCE MAX, stop the open power liftgate at the desired height and hold its lower switch for about two seconds until four beeps confirm the setting.
Check that your vehicle has it.
Verified for 2025 4Runner Hybrid vehicles with a power back door. The trim list is limited to TRD Off-Road Premium i-FORCE MAX, whose grade equipment includes the hands-free power liftgate.
- Retail trim / version
- TRD Off-Road Premium i-FORCE MAX
- Required equipment / service
- Power back door with lower liftgate switch, power back door
Does the documented scope match your car?
This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.
Published availability and qualifications
Verified for 2025 4Runner Hybrid vehicles with a power back door. The trim list is limited to TRD Off-Road Premium i-FORCE MAX, whose grade equipment includes the hands-free power liftgate.
Know what kind of control to look for.
This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.
Step by step.
- 01
Park on level ground and confirm safe clearance above and behind the liftgate.
- 02
Open the power back door and stop it at the desired position.
- 03
Press and hold the switch on the lower part of the back door for approximately two seconds.
- 04
Release after the buzzer sounds four times, then close and reopen the door to verify its new stop.
- 05
To restore the initial position, hold the same switch for about seven seconds and wait for four beeps followed by two more.
Important limits
- Choose a height that will not contact a garage door, ceiling, roof accessory or person.
- The most recently stored position, whether set by the liftgate switch or multi-information display, takes priority.
- Do not force the power back door while its motor is operating.
Quick checks.
- ✓If four beeps do not sound, stop the door again and hold the lower switch for the full two seconds.
- ✓If the door still uses the old position, check the multi-information-display setting because the last setting wins.
- ✓After reconnecting the 12-volt battery, close the back door manually once to re-enable proper power operation.
What happened on your vehicle?
Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.
2025 Toyota 4Runner Hybrid Owner's Manual — Adjusting power back door open position
Relevant section or page: Pages 143–144. We use the written official source to determine the steps and applicability shown above.
View 1 supporting reference
Reviewed with a visible trail.
Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.
- Published
- Last modified
- Source checked
Guide change history
- Initial verified publication.