Quick answer

On an equipped Gladiator in the permitted 4WD range, push the axle-lock control down for Rear Only or up for Front+Rear, verify the indicator, and press OFF to unlock.

Before you start

Check that your vehicle has it.

Availability

Verified for 2024 Gladiator models equipped with the Tru-Lok front and rear axle-lock system.

Required equipment / service
Gladiator equipped with Tru-Lok axle lockers
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • Gladiator equipped with Tru-Lok axle lockers
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified for 2024 Gladiator models equipped with the Tru-Lok front and rear axle-lock system.

Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Towing & power orientation diagram for Jeep Gladiator
Towing & power orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Stop or crawl slowly on loose terrain and select the 4WD range required by the cluster prompt.

  2. 02

    Push the axle-lock switch down to request Rear Only.

  3. 03

    When front locking is needed and permitted, push the switch up to request Front+Rear.

  4. 04

    Wait for the corresponding axle-lock indicator to confirm engagement before applying power.

  5. 05

    Press the axle-lock OFF button and confirm both lockers disengage before normal pavement driving.

!

Important limits

  • Use axle locks only in the allowed 4WD mode and on suitable low-traction terrain.
  • Locked axles reduce steering ability and can damage the driveline on high-traction pavement.
  • The indicator, not the switch position alone, confirms engagement.
If it does not work

Quick checks.

  • ✓If the indicator flashes, roll very slowly and reduce driveline bind without spinning tires.
  • ✓Confirm the correct transfer-case range.
  • ✓If a locker warning persists, disengage the system and obtain service.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

2024 Jeep Gladiator Owner Handbook — Axle Lock

Relevant section or page: 4x4 Operation. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.