Quick answer

On a 2025 Compass Trailhawk, stop, select Neutral with ignition ON/RUN or the engine running, and press 4WD LOW once; repeat while stopped in Neutral to disengage.

Before you start

Check that your vehicle has it.

Availability

Verified only for the 2025 Compass Trailhawk equipped with Active Drive Low; other Compass trims do not have the 4WD LOW button.

Required equipment / service
Active Drive Low
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • Active Drive Low
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified only for the 2025 Compass Trailhawk equipped with Active Drive Low; other Compass trims do not have the 4WD LOW button.

Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Four-wheel drive orientation diagram for Jeep Compass
Four-wheel drive orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Bring the Compass to a complete stop on a suitable loose or difficult surface.

  2. 02

    Keep the ignition in ON/RUN or the engine running and shift the transmission to Neutral.

  3. 03

    Press the 4WD LOW button once.

  4. 04

    Wait while the LOCK and LOW LEDs blink; proceed only after they stay on and the cluster shows 4WD LOW.

  5. 05

    To leave low range, stop again, select Neutral and press 4WD LOW once, then confirm its indicator clears.

!

Important limits

  • Use low range only for difficult low-speed conditions such as deep snow, mud, sand or steep terrain.
  • Avoid speeds above 25 mph (40 km/h) in 4WD LOW.
  • Do not attempt the shift while moving or with the transmission outside Neutral.
If it does not work

Quick checks.

  • ✓If the LEDs keep blinking, stop fully, hold the brake and reselect Neutral before retrying.
  • ✓Confirm the ignition is ON/RUN and the vehicle is a Trailhawk with the LOW button.
  • ✓A persistent Service 4WD message requires diagnosis before further off-road use.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

2025 Jeep Compass Owner's Manual — Active Drive With Low Control

Relevant section or page: Starting And Operating, page 89 — Enabling/Disabling 4WD LOW. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.