Quick answer

The remote-start button sequence runs the engine for 15 minutes; repeating it adds another 15 minutes, while holding the cancel control until the parking lamps switch off ends the session.

Before you start

Check that your vehicle has it.

Availability

Verified for 2025 U.S.-market Traverse vehicles equipped with Remote Vehicle Start.

Required equipment / service
Remote Vehicle Start
Compatibility check

Does the documented scope match your car?

This check combines the verified year, any source-supported powertrain scope, source-named trim/package and required equipment. It does not read a VIN or factory build record.

Source-named equipment or service
  • Remote Vehicle Start
Can you see the required control, menu or equipment on your vehicle?
Published availability and qualifications

Verified for 2025 U.S.-market Traverse vehicles equipped with Remote Vehicle Start.

Visual orientation

Know what kind of control to look for.

This original category diagram is an orientation aid, not a picture of your exact trim. Use the written labels and your vehicle manual to identify the real control.

Key fob & access orientation diagram for Chevrolet Traverse
Key fob & access orientationOriginal visual guide · controls vary by trim · not to scale
How to use it

Step by step.

  1. 01

    Make sure the Traverse is parked outdoors in a safe, ventilated location with the doors closed.

  2. 02

    Use the Remote Vehicle Start control on the key fob twice as shown in the fob diagram and confirm that the parking lamps respond.

  3. 03

    Repeat the same sequence during the first session if you need the one permitted additional 15-minute run period.

  4. 04

    After entering, press the brake and ENGINE START/STOP button before driving, or hold the remote-start cancel control until the parking lamps turn off to end the session early.

!

Important limits

  • Never remote-start in an enclosed garage because exhaust gases can accumulate.
  • Remote start does not make the vehicle ready to drive; the normal in-cabin start procedure is still required.
If it does not work

Quick checks.

  • ✓If the engine does not start, verify the doors and hood are closed and that no start-preventing warning is active.
  • ✓If the second extension is rejected, the allowed extension may already have been used; start the vehicle normally before the next remote-start cycle.
Owner feedback

What happened on your vehicle?

Your response is stored on this device. If you separately allow analytics, a non-account-linked guide/result event may also be measured. No VIN or personal information is requested.

Primary evidence

Getting to Know Your 2025 Chevrolet Traverse — Remote Vehicle Start

Relevant section or page: 4. We use the written official source to determine the steps and applicability shown above.

Open official source ↗
Editorial record

Reviewed with a visible trail.

Scope and steps were checked by Car Cheat Codes Editorial Review. A guide is narrowed or corrected when the source does not support a broader claim.

Published
Last modified
Source checked
Guide change history
  • Initial verified publication.